河道溢油事故环境风险评价中若干关键问题探讨

河道溢油事故已成为内河道突发性水环境污染的主要问题之一,尤其水源地突发性污染事件日益增多,对社会、经济和河道生态环境造成严重的不良影响。新建的水上项目必须通过溢油风险评价来分析项目建设投产后对周边的环境影响,目前溢油风险评价尚无统一的方法,且风险分析不够深入。本文基于国内外经典的油膜动力学模型及统计学等理论,明确溢油事故环境风险评价中事故源强、事故概率、溢油油膜影响范围、风险应急时间以及水厂吸水口关闭时间等几个关键问题的分析方法,以期进一步提高河道溢油事故的环境风险评价水平。     

pH和DO对好氧颗粒污泥去除高氨氮废水的影响研究

研究使用SBR成功培养的结构紧密、外形规则,具有良好脱氮性能的成熟好氧颗粒污泥处理高浓度氨氮废水,并探讨pH和DO对其处理效果的影响,旨在为工程实践提供理论依据。通过人工模拟废水,以蔗糖作为唯一碳源,NH4Cl为氮源,将进水NH4+-N浓度由300 mg/L逐步提高至900 mg/L,相应的NH4+-N负荷由0.6 kg/(m3.d)提高至1.8 kg/(m3.d),考察pH和DO对其处理效果的影响。研究结果表明:当控制反应器pH为8.0,曝气量为75 L/h时,好氧颗粒污泥脱氮的效果最好,氨氮去处率分别为96.70%9、2.33%。由于运行过程中每隔15 min监测每个反应器pH值,使其维持在各自pH值7.0±0.1范围内。这种酸碱度环境对异养菌等微生物并没有产生抑制作用;因此在各pH条件下,COD去除的所需时间和去除率基本没有差别。在不同的DO下,COD在初始的60 min里降解速度有明显区别。曝气量为150 L/h时,COD的降解速度最快,但是曝气量过大颗粒污泥内部厌氧区被压缩,因此选择最佳的曝气量为75 L/h。     

浙江省排污权有偿使用和交易政策法规研究

随着中国经济的高速发展和城市化进程的加快,环境资源的消耗进一步加大,环境资源面临枯竭问题已经严重影响到社会经济的可持续发展。建立排污权有偿使用与交易制度对于解决过高的环境治理成本问题具有重要作用。本文从排污权的基本法律理论入手,总结和分析我省排污权有偿使用和交易政策法规存在的问题,进而提出适合我省的政策建议,以期完善我省排污权有偿使用和交易的政策法规体系。     

改性人造沸石处理含黄玉铬洁(Ⅵ张焕)祯地下水的实验研究

为了提高人造沸石对地下水中铬(Ⅵ)的去除能力,采用氯化铝对人造沸石进行改性。确定最佳改性条件:20%氯化铝溶液,液固比12 mL/g,室温下以180 r/min振荡改性8 h;最佳除Cr(Ⅵ)条件:pH值为4～8,液固比为33.3 mL/g,室温下水浴恒温振荡2 h。改性沸石对铬(Ⅵ)的吸附符合Langmuir及Freundlich等温线方程,由Langmuir吸附等温线可得其吸附容量为5.624 mg/g。在最佳反应条件下,水样中铬(Ⅵ)浓度可由5 mg/L下降到0.026 mg/L,低于0.05 mg/L,满足GB/T 14848—93《地下水环境质量标准》Ⅲ类标准。     

Ultrafine particle emission characteristics of diesel engine by on-board and test bench measurement

This study investigated the emission characteristics of ultrafine particles based on test bench and on-board measurements. The bench test results showed the ultrafine particle number concentration of the diesel engine to be in the range of (0.56-8.35) × 10⁸ cm^-3. The on-board measurement results illustrated that the ultrafine particles were strongly correlated with changes in real-world driving cycles. The particle number concentration was down to 2.0 × 10⁶ cm^-3 and 2.7 × 10⁷ cm^-3 under decelerating and idling operations and as high as 5.0 × 10⁸ cm^-3 under accelerating operation. It was also indicated that the particle number measured by the two methods increased with the growth of engine load at each engine speed in both cases. The particle number presented a "U" shaped distribution with changing speed at high engine load conditions, which implies that the particle number will reach its lowest level at medium engine speeds. The particle sizes of both measurements showed single mode distributions. The peak of particle size was located at about 50-80 nm in the accumulation mode particle range. Nucleation mode particles will significantly increase at low engine load operations like idling and decelerating caused by the high concentration of unburned organic compounds.     

Identification of rice cultivars with low brown rice mixed cadmium and lead contents and their interactions with the micronutrients iron, zinc, nickel and manganese

Paddy fields in mining areas are usually co-contaminated by a cocktail of mixed toxic heavy metals (e.g., Cd and Pb in Pb/Zn mines). However, previous studies on rice cultivars screened for effective metal exclusion have mostly focused on individual metals, and have been conducted under pot-trial or hydroponic solution conditions. This study identified rice cultivars with both low Cd and Pb accumulation under Cd-and Pb-contaminated field conditions, and the interactions of the toxic elements Cd and Pb with the micronutrient elements Fe, Zn, Mn and Ni were also studied. Among 32 rice cultivars tested, there were significant differences in Cd (0.06-0.59 mg/kg) and Pb (0.25-3.15 mg/kg) levels in their brown rice, and similar results were also found for the micronutrient elements. Significant decreases in concentrations of Fe and Mn were detected with increasing Cd concentrations and a significant elevation in Fe, Mn and Ni with increasing Pb concentrations. A similar result was also shown by Cd and Ni. Three cultivars were identified with a combination of low brown rice Cd and Pb, high micronutrient and grain yield (Wufengyou 2168, Tianyou 196 and Guinongzhan). Present results suggest that it is possible to breed rice cultivars with low mixed toxic element (Cd, Pb) and high micronutrient contents along with high grain yields, thus ensuring food safety and quality.     

回流对陈垃圾生物反应器处理老年渗滤液污染物影响

为了研究回流对陈垃圾反应器处理老年渗滤液污染物的影响,构建了回流的陈垃圾生物反应器,试验了不同温度、负荷和回流比条件下反应器对污染物的去除效果。结果表明,在较低水力负荷12.8~25.5 L/(d.m2)的情况下,陈垃圾反应器对NH3-N、BOD5和COD等污染物的去除率分别达到90%、95%和70%以上。在不同温度下提高水力负荷,回流会抑制氨氮和COD的去除,但可显著提高TN的去除率,表明回流可作为提高老年渗滤液TN去除率的途径之一。利用氮同位素示踪技术发现反应器中有Anammox脱氮途径存在。但是可利用碳源的缺乏仍是提高老年渗滤液脱氮效率的限制因子。     

基于循环特性的镍氢和锂离子电池环境影响机制分析

为了了解镍氢电池和锂离子电池在生产、使用、废弃或回收过程中的环境影响,建立了一种简单快速的二次电池环境影响机制分析方法。通过生命周期评价(LCA)方法,采用Eco-indicator99体系,综合考虑电池循环容量衰减和循环次数的影响,建立了二次电池环境影响机制分析模型,并运用此模型对两种实验用二次电池(镍氢电池和锂离子电池)的环境影响机制进行了研究。结果表明:1)在所选取的两种二次电池当中,锂离子(Li-ion)电池的环境影响明显比镍氢(Ni-MH)电池的低;2)随着循环次数的增加Li-ion电池环境影响衰减比Ni-MH电池的明显,即随着使用循环次数的增加,Li-ion电池对环境的影响会降低到更多。综合来说,所选取的Li-ion电池比Ni-MH电池更具环境可持续性。文中所提出的环境影响机制分析模型同样可以应用于其他二次电池,以期为环境友好型二次电池的开发提供帮助。     

基于传声器阵列的声源定位技术的应用

基于传声器阵列的声源定位技术中的两个主要方法,STSF和Beamforming声源定位技术两者的实现方法不同。通过对STSF和Beamforming声源定位技术的推导,给出了两种测量技术适用的频率范围和空间范围,从理论上对其应用范围的差异进行了说明,并提出在实际测量中如何选择合适的声源定位方法。结合两种测量技术的特点,提出声源定位技术下一阶段研究的重点。     

污水生化处理耗氧量计算与应用

根据各类型好氧工艺运行的特点,结合多年设计经验,给出详细计算公式和参数选择范围,说明每个参数含义。